Step 5 in making Apple roses

-

Step 5: Dough

Picture of Dough
IMG_3851.jpg
Unroll your dough on a lightly floured surface. Using a sharp knife cut 2 inch (5.08 cm) wide strips.

Comments

Post a Comment

Popular posts from this blog

Making of Rubber Stamps in an easy way

-
Image
How to make a high quality stamp out of your favorite logo or symbol. You will need the following materials: Speedball 6-Inch by 12-Inch Speedy-Carve Block Speedball Linoleum Cutter Assortment 1 which contains a straight bits & gouging bits 5 Minute Two-Part Epoxy Scrap wood for handle Polyurethane spray and finally an ink pad! Step 1: Select a favorite symbol or logo to use as a stamp Start by selecting a few black and white logos, symbols or other emblems that you would be interested in having a stamp of. It could even be some text. Just try to avoid an image with very thin lines as these can be difficult to carve, and can bend/collapse under the pressure of stamping down. Using an image editing program or even MS Word, create a black background and arrange them to appear side by side. Having the black background helps a lot when transferring images to rubber sheet. *Note*  There is no need to mirror/reverse anything as they wil...
Read more

Woven paracord bracelet/watchband :Step 1

-
Image
This tutorial will show how to make a Paracord  bracelet or watch band using a weaving method. Step 1: Supplies For this project, you'll need approximately 10 feet of paracord, scissors, lighter, tape measure, hemostats, watch, and a  5/8" side release buckle . Paracord can be found at local Army/Navy stores or from various online sources:  A mazon ,  S hopclues , ebay, etc... The actual amount of paracord that will be used depends on your wrist size, cord, and tying technique(tight/loose). A typical wrist is about 8.5 inches and I actually used around 8 or 9 feet after finishing the bracelet/watchband. So using 10 feet is usually a safe estimate for most folks, since having too much cord is better than coming up short when making your project. *If making a watchband, the watch needs to have about 5/8" space between the lugs(where the watch pins go) so that 5 strands of paracord will fit.
Read more

Door Mat Using Old Clothing

-
Image
People normally discard old clothing. Here in this article i am going to suggest you a beautiful technique to reuse the old clothes in other forms.My mom have used an old torn cloth to make a door mat. Please go through the article on how to make a door mat out of waste cloth Step 1: Cut Cloth Into Strips This one is a closed Lungi which is worn around the waist. It can not be worn any more due to the large tear in it. First cut and open the Lungi. It will be about 6 ft long after cutting. The width is about 4 ft. Cut 3 inch wide strips from it. You can cut about 12 strips of 6 ft long each from this cloth Step 2: Tie Strips of Cloth Take 3 strips in hand and tie them together at one end Insert all three tied end of strips in the door or window grill Step 3: Braid All Three Strips Together Tightly braid the three strips of cloth starting from the tied end. It is same a...
Read more