Step 9: Wall Lamp
I drilled a large hole in one piece with a diamond core hole saw.
I also drilled a smaller hole in another piece (to hang the lamp)
Step 10: Wall Lamp
I sanded both pieces with silicon carbide.
Woven paracord bracelet/watchband :Step 1
This tutorial will show how to make a Paracord bracelet or watch band using a weaving method. Step 1: Supplies For this project, you'll need approximately 10 feet of paracord, scissors, lighter, tape measure, hemostats, watch, and a 5/8" side release buckle . Paracord can be found at local Army/Navy stores or from various online sources: A mazon , S hopclues , ebay, etc... The actual amount of paracord that will be used depends on your wrist size, cord, and tying technique(tight/loose). A typical wrist is about 8.5 inches and I actually used around 8 or 9 feet after finishing the bracelet/watchband. So using 10 feet is usually a safe estimate for most folks, since having too much cord is better than coming up short when making your project. *If making a watchband, the watch needs to have about 5/8" space between the lugs(where the watch pins go) so that 5 strands of paracord will fit.
Comments
Post a Comment